Custom Test Parameters
Our tests run with standard parameters, however sometimes your simulations may need a bit of fine tuning.
We have created a pop up found left of the simulation buttons.
Here you can enable the Hump Test button.
You can "Save Output Variables" which means when you run a Simulation you can get all the output variables to download. (We recommend not using this unless you need to).
Below is where you can tune parameters and run more simulations. The buttons are greyed out until you change the parameters from the default. At least one default simulation must be run first. For Lane Change results, the SRT test must be run so RA can be calculated and is disabled until SRT is run.
It is limited to run only one test at a time. When you run a test the results will show in the Results Table below, assessed with the Assessment Options chosen in the PBS toolbar.
All results will be visible in the Results table denoted by version ._ As the tests are independent, each one is "pushed up". The number after the version number also aligns with the files found in the exported model. E.g. for row 3.10, if you wanted to see the UM model for even closer analysis, it will be laneChange10, lowSpeedTurn10, etc.
